Vintage Audio
rcn.com.ua

Sansui SA-F1

Предварительный усилитель. Индикатор питания на передней панели. Регулировка НЧ, ВЧ, баланса. Переключатели входных, выходных каналов. Кнопки включения/выключения Subsonic, Tone, Loudness. Гармонические искажения менее 0.005%, вес 6кг., черный цвет.

Sansui SA-F1

Sansui CA-F1

Preamplifier

Total Harmonic Distortion:

Overall (AUX to PRE Output): less than 0 005% at or below rated output level

Intermodulation Distortion (70Hz: 7,000Hz = 4:1 SMPTE method)

Overall (AUX to PRE Output): less than 0.005% at or below rated output level

Frequency Response (at 1 watt):

Overall (from AUX): 5 to 600,000Hz +0dB, -3dB, 5 to 100.000Hz +0dB, -0.2dB

RIAA Curve Deviation (20 to 20.000Hz): +0.2dB, -0.2dB

Input Sensitivity and Impedance (at 1,000Hz):

Phono (MC): 0.1mV (10 ohms cartridge termination), 33 ohms (for MC cartridges having internal impedance of up to 200 ohms)

Phono (MM): 2.5mV, 47k ohms

AUX: 150mV, 47k ohms

Maximum Input Capability Phono (MC): 24mV RMS (at 1,000Hz 0.03% THD)

Phono (MM): 350mV RMS (at 1,000Hz 0 008% THD)

Output Voltage and Impedance (at 1,000Hz):

Tape REC (PIN): 150mV/600 ohms into 47k ohm load

Preamplifier Output: 1V/600 ohms into 47k ohm load

Maximum Preamplifier Output (at 0.005% THD): 10V/600 ohms into 47k ohm load

Hum and Noise (IHF):

Phono (MC): 75dB

Phono (MM): 90dB

AUX: 100dB

Channel Separation (at 1,000Hz):

Phono (MC): 75dB

Phono (MM): 85dB

AUX: 88dB

Bass: +7dB, -9dBat50Hz

Treble: +7dB, -7dB at 15kHz

Loudness (volume control at -30dB position): + 9dB at 50Hz +5dB at 10kHz

Subsonic Filter: -3dB at 16Hz (6dB/oct.)

Rise Time: 0.6µSec

AC Outlets: unswitched total 450 watts

Power Voltage: 100, 120, 220, 240V 50/60HZ

Power Consumption: 45 watts

Semiconductors: 85 Transistors; 28 Diodes; 29 FETs; 2 ICs

Dimensions (W x H x D, mm): 430 x 60 x 435

Weight: 6kg (13.2lbs.) Net